For the 3M adhesive tape to bond with the mounting surface, the surface needs to be cleaned thoroughly. We can't stress how important this step is. Your application surface must be free from all dirt, grease, and grime before starting this guide. Do not use the provided alcohol wipes at this point, we will do that later before applying the adhesive tape.
1. Measure The Wire Hider
The first thing you'll need to do is measure out the required length for your wire hider. We suggest using the actual wire hider for this. Lay down the wire concealer rubber on yours. Use a sharp box-cutter to make a small incision into the rubber at your desired length then lay the rubber on a flat surface and complete the cut.
2. Apply 3M Tape To Concealer
Peel off a small amount of the 3m tape then firmly press the tape to the bottom of the concealer. Slowly make your way up the concealer, peeling off a small amount of the adhesive tape barrier and pressing as you go.
3. Clean Mounting Surface
Using the provided alcohol wipe, thoroughly wipe the mounting surface and allow it to dry. The alcohol will evaporate and dry naturally very quickly.
4. Mount The Concealer
Slowly peel back the adhesive tape barrier and position the wire hider in place, while pressing down firmly.
5. Press & Hold
It's important to press and hold the concealer in place for 30 seconds at a time to create a strong bond with the mounting surface.
6. Conceal Your Wires
Once your concealer is bonded with the mounting surface, run your wires through the concealer channel and clip as you make your way through.