The installation of the STEDI switch panel is designed to be extremely easy and only takes a matter of minutes to install. The panel is provisioned to hold eight STEDI Square-type push switches.
- Gently pry the top speaker cover via the front corners until it pops. The trim tool will make it easier.
- Once the panel is free, carefully remove it to ensure the factory clips are intact.
- Remove factory clips using a small flathead screwdriver and transfer them onto the STEDI panel.
- To create additional clearance for switch wiring, use the supplied template to radius out the tab of the display module to the hole located here.
- The hole drops directly to the passenger footwell behind the glovebox.
- To remove the display module, use a 7mm socket to remove the 3 bolts holding the module.
- Apply the template to the base of the module, aligning the tabs.
- Drill a pilot hole in the centre point, then expand to the desired size. Our recommendation is 9mm
- Feed the wiring through the hole to the connect to desired switches.
- Once all desired switches are connected and wiring tucked away.
- The Panel can be dropped into place starting from the rear and pressed down for all clips to locate in the slots.
Comments
0 comments
Please sign in to leave a comment.