ST1K Series Light Bars Complete Guide

IMPORTANT NOTES:

- All three M10 bolts must be used to mount the base of the U Bracket to your vehicle. Using only one or two bolts will result in excess vibration of the lamp and ultimately result in bracket failure.

- Before fitting stainless steel hardware, we recommend applying a small amount of anti-seize to the threads of any mounting bolts.

INSTALLATION

For wiring instructions, Click Here.

Our ST1K Series bars will come with either side brackets, sliding brackets, or both. Below is a brief run-through on both mounting styles to help you through installation.

SIDE BRACKETS:
Best described using the diagram below, the side brackets should be assembled in order of components: Plastic Washer > Bracket Arm > Washer > Spring Washer > Bolt.

SLIDING BRACKETS:
The bracket can be assembled prior to installation. Using the wider opening in the channel of the light bar, insert the bracket and slide to the desired position for mounting. Once the bracket is in position, tighten down the 2 bolts to secure the position in the channel.