STEDI TYPE X V1 INSTALLATION INSTRUCTIONS
The following are the 3 groups of components that you will have for each light including nuts, bolts & clips. Vibration dampeners and finally the U-Bracket.
1. First up is the nuts that will slot into the back of the housing. You will notice there are 2 slots on each side. The inner side will fit the larger nut and the outer fits the smaller nut with the top side of the nut facing towards the center of the light and lastly for this step, attach the clips each side that will secure the nuts in place.
2. Next up are the side bolts, these only need to be moderately tight at this stage as you will need to adjust the tilt angle when you move on to the install on to your vehicle. Now for the question that everyone asks, "what are the rubber plates for?". These are supplied to absorb vibration whilst driving that if not controlled, can shorten the life span of your lights. For customers using only one mounting bolt, we recommend the dampener plates being used as a must. With only a single point of mounting the lights are much more susceptible to vibration. To install the dampeners place one on the top and one on the bottom of the u-bracket with the rubber side facing in towards the bracket as per the third picture below.